Guide / On the schematic

Measurements

Record bench measurements where they were taken, grouped by test condition.

On this pagePlace a measurementReview measurements

Place a measurement

  1. Click Annotate and choose Measure (under Click to place).
  2. Click the test point or net on the schematic where you measured.
  3. Type the value, e.g. 3.3V or 120mA, and optionally a topic or group (e.g. "Leader mode", "Full load").
  4. Click Add. Click the same point again to add a measurement under another topic; the same topic replaces its old value.

Review measurements

  1. Open the Measure tab of the annotation panel: points are listed with their measurements, grouped by topic.
  2. Click a point to jump to it on the schematic.
  3. Use a measured value as an equation input (see Equations).
Previous← Annotations

Something unclear or missing? Tell us.